Juniper EX6210 Complete Hardware Manual page 271

Copyright © 2014, Juniper Networks, Inc.
CAUTION: The switch is maximally protected inside the shipping box. Pack
the switch only in its original shipping box, securely bolted to the original
wooden shipping pallet.
Do not pack the switch in anything except its original container or the switch
might be damaged in transit.
To pack the switch (see Figure 102 on page
Move the wooden pallet and packing material to a staging area as close to the switch
1.
as possible. Make sure there is enough space to move the chassis from the rack or
cabinet to the wooden pallet.
Remove the switch from the rack or cabinet. For EX6200 switches, see
2.
an EX6210 Switch from a Rack or Cabinet" on page
Move the chassis to the shipping pallet (see
Switches" on page 273). Position the switch on the pallet so that the front of the switch
is facing the silkscreened "front" mark on the pallet. The pallet also has crop marks
to guide you in positioning the chassis.
Use the 7/16-in. or 11-mm open-end or socket wrench to install the four sets of brackets
3.
and bolts that secure the chassis to the wooden pallet (on the chassis side).
Use the 10-mm open-end or socket wrench to install the four sets of brackets and
4.
bolts that secure the chassis to the wooden pallet (on the pallet side).
Slide the plastic cover over the switch chassis. The plastic cover is part of the switch's
5.
original packing materials.
Replace the foam padding on top of the chassis.
6.
Place the power cords in the accessory box.
7.
Place the accessory box in its slot in the foam padding. See
8.
List) for an EX6210 Switch" on page 130
contents of the accessory box.
Slide the cardboard box over the chassis, making sure that the arrows on the box point
9.
up and the pallet fasteners to secure the cardboard box to the wooden pallet are near
the bottom.
Securely tape the box close, if it was opened while unpacking the switch.
10.
Attach the cardboard box to the wooden pallet using the four pallet fasteners attached
11.
to the pallet. See Figure 101 on page
the depression in each pallet fastener, then slide each fastener into its corresponding
slot in the cardboard box and release the ridges to secure the latch.
Chapter 15: Returning the Switch or Switch Components
253):
202.
"Chassis Lifting Guidelines for EX6200
"Parts Inventory (Packing
to verify that you have included all the proper
252. Squeeze together the two ridges ("fins") in
"Removing
251