Dc Power Supply Leds In An Ex6200 Switch; Table 31: N+N Power Redundancy Configurations For Different Ex6210 Switch Configurations Using 2100 W Dc Power Supplies - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

DC Power Supply LEDs in an EX6200 Switch

52
Table 31 on page 52 lists the N+N power requirements of an EX6210 switch configuration
that use 2100 W DC power supplies.
Table 31: N+N Power Redundancy Configurations for Different EX6210
Switch Configurations Using 2100 W DC Power Supplies
Switch Nominal Input
Configuration Voltage
96-port RJ-45 –48 VDC through
system –60 VDC
configuration
96-port PoE+ –48 VDC through
system –60 VDC
configuration
Fully loaded –48 VDC through
with two SFP –60 VDC
line cards
Fully loaded –48 VDC through
with eight –60 VDC
PoE+ line
cards
DC Power Supply LEDs in an EX6200 Switch on page 52
Installing a DC Power Supply in an EX6200 Switch on page 153
Removing a DC Power Supply from an EX6200 Switch on page 211
A DC power supply has three LEDs on its faceplate:
LEDs. All three LEDs display information about the status of the power supply. See
Figure 27 on page 53.
Minimum
Number of
Ports Enabled Power Supplies
for PoE+ Needed (N)
NA 1
0 1
96 2
NA 1
0 2
64 2
384 Not supported
,
INPUT OK OUTPUT OK
Copyright © 2014, Juniper Networks, Inc.
Power
Supplies
Needed for
N+N
Redundancy
2
2
4
2
4
4
Not supported
, and
FAIL