Performing Initial Configuration; Ex6200 Switch Default Configuration - Juniper EX6210 Complete Hardware Manual

CHAPTER 11

Performing Initial Configuration

EX6200 Switch Default Configuration

Copyright © 2014, Juniper Networks, Inc.
EX6200 Switch Default Configuration on page 191
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 192
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 195
Each EX6200 switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as the Address Resolution
Protocol (ARP) aging timer, while also enabling the Link Layer Discovery Protocol (LLDP)
protocol, the Rapid Spanning Tree Protocol (RSTP), Internet Group Management Protocol
(IGMP) snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.
This topic shows the factory default configuration file of an EX6200 switch:
protocols {
lldp {
interface all;
}
lldp-med {
interface all;
}
igmp-snooping {
vlan all;
}
rstp;
}
ethernet-switching-options {
storm-control {
interface all;
}
}
poe {
interface all;
}
191