Table 23: Network Port Leds On Line Cards In An Ex6200 Switch-Link/Activity; Led; Table 24: Network Port Leds On Line Cards In An Ex6200 Switch-Status - Juniper EX6210 Complete Hardware Manual

Table 23: Network Port LEDs on Line Cards in an EX6200 Switch—Link/Activity LED

LED

Link/Activity
Table 24: Network Port LEDs on Line Cards in an EX6200 Switch—Status LED
LED
Status
Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
Color
Green
The LED labeled Status in
parameters. The port parameters are administrative status, speed, duplex mode, and
Power over Ethernet (PoE) status.
Table 24 on page 37 describes the Status LED. From the Idle menu of the LCD panel, use
the button on the LCD panel to toggle between the ADM, SPD, DPX, and PoE
Enter
indicators.
LCD Indicator
LED: ADM
LED: SPD
LED: DPX
LED: PoE
48-Port RJ-45 Line Card in an EX6200 Switch on page 31
48-Port PoE+ Line Card in an EX6200 Switch on page 32
State and Description
On steadily—The port and the link are active, but there is no
link activity.
Blinking—The port and the link are active, and there is link
activity.
Off—The port is not active.
Figure 18 on page 36 indicate the status of one of the four port
State, Color, and Description
Indicates the administrative status (enabled or disabled). The
status indicators are:
Green—Administrative status enabled.
Yellow—The port is down.
Unlit—Administrative status disabled.
Indicates the speed. The speed indicators are different in the
line cards.
The speed indicators for 48-port RJ-45 and the 48-port PoE+
line cards are:
Unlit—10 Mbps
Green—Blinking—100 Mbps
Green—On steadily—1/10 Gbps
Indicates the duplex mode. The status indicators are:
Green—Port is set to full-duplex mode.
Unlit—Port is not set to full-duplex mode.
Indicates the PoE mode. The status indicators are:
Green—PoE is enabled on the port and a device is drawing
power.
Yellow—PoE is enabled on the port, but no power is drawn
from the port.
Unlit—PoE is not enabled on the port.
Chapter 2: Component Descriptions
37