Juniper EX6210 Complete Hardware Manual page 244

Complete Hardware Guide for EX6210 Ethernet Switches
224
A dust cover to cover the port
Figure 87 on page 225 shows how to remove a QSFP+ transceiver. The procedure is the
same for all types of transceivers except the CFP transceivers.
To remove a transceiver from an EX Series switch:
Place the antistatic bag or antistatic mat on a flat, stable surface.
1.
Label the cable connected to the transceiver so that you can reconnect it correctly.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean
and prevents accidental exposure to laser light.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Remove the cable connected to the transceiver (see
3.
Cable from an EX Series Switch" on page
each fiber-optic cable connector with a rubber safety cap immediately after
disconnecting the fiber-optic cables.
"Disconnecting a Fiber-Optic
222). Cover the transceiver and the end of
Copyright © 2014, Juniper Networks, Inc.