Figure 27: Dc Power Supply Leds In An Ex6200 Switch; Table 32: Dc Power Supply Leds In Ex6200 Switches - Juniper EX6210 Complete Hardware Manual

Table 32: DC Power Supply LEDs in EX6200 Switches

LED
INPUT OK
OUTPUT OK
FAIL
Copyright © 2014, Juniper Networks, Inc.

Figure 27: DC Power Supply LEDs in an EX6200 Switch

INP UT
OUT PUT
OK FAIL
OK
Input
Fail
OK LED
LED
Output
OK LED
Table 32 on page 53 describes the LEDs on a DC power supply in EX6200 switches.
State
Unlit
Green
Unlit
Green
Unlit
Red
Chapter 2: Component Descriptions
Description
Indicates one of the following:
Power supply is disconnected from DC power feed.
No DC power input.
On steadily—DC power input voltage is within
operating range (–40 VDC through –72 VDC).
Blinking—DC power input voltage is not within
operating range (-40 VDC through -72 VDC).
Indicates one of the following:
DC output voltage is not within normal operating
range.
Power supply is not supplying DC power correctly.
On steadily—DC power output is within normal
operating range.
Blinking—DC output voltage is not within normal
operating range.
Power supply is functioning normally.
On steadily—Power supply has failed.
53