Connecting An Ex Series Switch To A Network For Out-Of-Band Management; Figure 72: Connecting An Ex Series Switch Directly To A Management; Console; Figure 73: Ethernet Cable Connector - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

Connecting an EX Series Switch to a Network for Out-of-Band Management

188

Figure 72: Connecting an EX Series Switch Directly to a Management

Console

Configuring the Console Port Type (CLI Procedure)
Connecting an EX Series Switch to a Network for Out-of-Band Management on page 188
Console Port Connector Pinout Information for an EX Series Switch on page 58
Cables Connecting the EX6200 Switch to Management Devices on page 103
Cables Connecting the EX8200 Switch to Management Devices
This topic applies to multiple hardware devices in the EX Series product family, which
includes switches and the XRE200 External Routing Engine.
You can monitor and manage these devices by using a dedicated management channel.
Each device has a management port with an RJ-45 connector for out-of-band
management. Use the management port to connect the EX Series switch or external
Routing Engine to the management device.
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the device.
Ethernet cable supplied with the device.

Figure 73: Ethernet Cable Connector

To connect a device to a network for out-of-band management (see
Figure 74 on page 189):
Connect one end of the Ethernet cable to the management port (labeled
1.
) on the device.
ETHERNET
For the location of the
MGMT
See EX2200 Switches Hardware Overview.
See Rear Panel of an EX3200 Switch.
See Rear Panel of an EX3300 Switch.
See Rear Panel of an EX4200 Switch.
See EX4300 Switches Hardware Overview
Figure 73 on page 188 shows the RJ-45 connector of the
or port on different devices:
ETHERNET
Copyright © 2014, Juniper Networks, Inc.
MGMT or