Connecting And Configuring An Ex Series Switch (J-Web Procedure) - Juniper EX6210 Complete Hardware Manual

Connecting and Configuring an EX Series Switch (J-Web Procedure)

Copyright © 2014, Juniper Networks, Inc.
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the command-line interface (CLI) and the other is by using the
J-Web interface.
NOTE: EX2200-24T-4G-DC switches do not support switch connection and
configuration through J-Web procedure.
This topic describes the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the
management PC that you will connect to the switch so that the PC can obtain
an IP address dynamically.
NOTE: Read the following steps before you begin the configuration. You
must complete the initial configuration by using EZSetup within 10 minutes.
The switch exits EZSetup after 10 minutes and reverts to the factory default
configuration, and the PC loses connectivity to the switch.
EX2200 and EX2200-C switch—The LEDs on the network ports on the
front panel blink when the switch is in the initial setup mode.
EX3200, EX3300, EX4200, EX4300, EX4500, EX4550, EX6200, or EX8200
switch—The LCD panel displays a count-down timer when the switch is in
initial setup mode.
Chapter 11: Performing Initial Configuration
195