Figure 48: Installing A 2500 W Ac Power Supply In An Ex6200 Switch; Figure 49: Installing A 5000 W Ac Power Supply In An Ex6200 Switch - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation
152
seated in the slot. Ensure the power supply faceplate is flush with any adjacent power
supply faceplates or power supply cover panels.
NOTE: Power supplies can be installed in any slot. You need not install
the power supplies in serial order.
Push the two captive screws on the front top of the power supply into the power
7.
supply faceplate. Ensure that the screws are seated inside the corresponding holes
on the chassis.
Tighten the captive screws by turning them clockwise using the screwdriver.
8.
CAUTION: Do not overtighten the screws. Applying excessive force might
damage the screws or power supply.
When the screws are tight enough, the power supply locks into the switch chassis.
To connect power to an AC power supply, see
Switch" on page 177.

Figure 48: Installing a 2500 W AC Power Supply in an EX6200 Switch

100-1 20V/2
00-24 0V-15
47-63 Hz A
100-1 20V/2
STAN D BY
ON
INPU T OUTP UT
FAIL
OK
OK
STAN D BY
INPU T
OUTP UT
OK
Power supply
blank shelf
Handle

Figure 49: Installing a 5000 W AC Power Supply in an EX6200 Switch

Captive screws
Handle
Connecting AC Power to an EX6200 Switch on page 177
Removing an AC Power Supply from an EX6200 Switch on page 209
AC Power Supplies in an EX6200 Switch on page 38
"Connecting AC Power to an EX6200
Captive screws
9
00-24 0V-15
A
47-63 Hz
100-1 20V/2
00-24 0V-15
47-63 Hz A
ON
FAIL
OK
STAN D BY
ON
INPU T
100-1 20V/2 OUTP UT
FAIL
00-24 0V~1 OK OK
47-63 Hz 5A
STAN DBY
ON
INPUT OUTP UT
OK FAIL
OK
8
9
Copyright © 2014, Juniper Networks, Inc.