Connecting Ac Power To An Ex6200 Switch - Juniper EX6210 Complete Hardware Manual

Connecting AC Power to an EX6200 Switch

Copyright © 2014, Juniper Networks, Inc.
Connecting AC Power to an EX4550 Switch
Connecting DC Power to an EX4550 Switch
Connecting AC Power to an EX6200 Switch on page 177
Connecting DC Power to an EX6200 Switch on page 180
Connecting AC Power to an EX8200 Switch
Connecting DC Power to an EX8200 Switch
Connecting AC Power to an EX9204 Switch
Connecting DC Power to an EX9204 Switch
Connecting AC Power to an EX9208 Switch
Connecting DC Power to an EX9208 Switch
Connecting AC Power to an EX9214 Switch
Connecting DC Power to an EX9214 Switch
General Safety Guidelines and Warnings on page 259
Grounded Equipment Warning on page 279
EX6200 switches can be configured with up to four AC power supplies. After you have
installed at least one power supply, you can connect power to the switch.
CAUTION: Mixing different types of power supplies (AC and DC or AC power
supplies of different wattage) in the same chassis is not supported.
Mixing low-voltage input line and high-voltage input line power feeds in the
same chassis is not supported.
NOTE: Each AC power supply must be connected to a dedicated AC power
feed.
Before you begin to connect power to the switch:
Ensure you understand how to prevent ESD damage. See
Discharge Damage" on page
Ensure that you have connected the switch chassis to earth ground.
288.
Chapter 10: Connecting the Switch
"Prevention of Electrostatic
177