Management Port Leds In Ex6200 Switches; Figure 11: Leds On The Management Port On An Ex6200 Switch; Table 15: Status Led On An Uplink Port On Ex6200 Switches - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches

Table 15: Status LED on an Uplink Port on EX6200 Switches

LED
Status
Related
Documentation

Management Port LEDs in EX6200 Switches

30
LCD Indicator
LED: ADM
LED: DPX
LED: PoE
LED:SPD
Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch on page 26
SRE Module LEDs in an EX6200 Switch on page 28
Each Switch Fabric and Routing Engine (SRE) module has two management ports: a
10/100/1000 BASE-T port and a Gigabit Ethernet SFP management port.
Each management port on EX6200 switches has two LEDs that indicate link/activity
and port status (see Figure 11 on page
full-duplex and the speed is set to 1000 Mbps.

Figure 11: LEDs on the Management Port on an EX6200 Switch

Link/
Activity
Table 16 on page 31 describes the Link/Activity LED.
State and Description
Indicates the administrative status (enabled or disabled). The
status indicators are:
Green (On steadily)—Administrative status is enabled.
Off—Administrative status is disabled.
Indicates the duplex mode. The status indicators are:
Green (On steadily)—Port is set to full-duplex mode
Off—Port is set to half-duplex mode
PoE is not enabled on uplink ports; therefore, the LED for those
ports is always unlit.
Off—PoE is not enabled on the port.
Indicates the speed. The speed indicators are:
Green (On steadily)—1/10 Gbps or auto
Green (Blinking)—100 Mbps
Off—10 Mbps/ link is down
30). By default, each management port is set to
Link/
Status
Activity
Status
Management
ports
Copyright © 2014, Juniper Networks, Inc.