Figure 64: Power Cord Retainer In A 2500 W Ac Power Supply; Figure 65: Power Cord Retainers In A 5000 W Ac Power Supply - Juniper EX6210 Complete Hardware Manual

Copyright © 2014, Juniper Networks, Inc.

Figure 64: Power Cord Retainer in a 2500 W AC Power Supply

10 0-1 20 V/2
00 -24 0V -15
47 -63 Hz
ST AN D BY
INP UT
OU TP UT
OK
OK
Adjustment
nut Retainer clip

Figure 65: Power Cord Retainers in a 5000 W AC Power Supply

Adjustment Retainer clip
nut
Locate the power cord or cords shipped with the switch; the cords have plugs
5.
appropriate for your geographical location.
Insert the coupler end of the power cord into the AC appliance inlet on the AC power
6.
supply faceplate.
NOTE: If the optional power cord tray is installed, thread the power cord
through the power cord tray.
Push the cord (close to the coupler end) into the slot in the adjustment nut of the
7.
power cord retainer. Rotate the nut until it is tight against the base of the coupler and
the slot in the nut is turned 90° from the top of the switch. See
or Figure 67 on page 180.
Repeat Steps 4 through
8.
inlet on the 5000 W AC power supply.
If the AC power source outlet has a power switch, set it to the OFF (0) position.
9.
Insert the power cord plug into an AC power source outlet.
10.
A
ON
FA IL
7 if you are connecting a power cord to the second appliance
Chapter 10: Connecting the Switch
Figure 66 on page 180
179