Figure 56: Sre Module Cover Panel; Figure 57: Open And Closed Positions Of The Line Card Ejector Lever - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
162

Figure 56: SRE Module Cover Panel

SRE module
filler panel
SRE module
cover panel
Line card
cover panel
CAUTION: Do not lift the line card by holding the ejector levers on the
faceplate or the edge connectors. The levers cannot support the weight
of the line card. Lifting the line card by the levers might bend them. Bent
levers prevent line cards from being properly seated in the chassis.
Taking care not to touch line card components, pins, leads, or solder connections,
3.
remove the line card from its bag.
NOTE: Inspect the connector edge of the line card for physical damage.
Installing a damaged line card might damage the switch.
Grasp the ejector levers on the faceplate of the line card and pull them outward until
4.
they are fully open (see

Figure 57: Open and Closed Positions of the Line Card Ejector Lever

Open
Place one hand around the faceplate of the line card and the other hand under the
5.
line card to support it.
Figure 57 on page 162).
Closed
Line card
cover panels
Copyright © 2014, Juniper Networks, Inc.