Figure 76: Removing An Ex6210 Switch Chassis Using A Mechanical Lift - Juniper EX6210 Complete Hardware Manual

Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
To remove the switch using a lift (see
Use the appropriate Phillips (+) screwdriver to remove the screws that attach the
1.
grounding lug (with grounding cable attached) to the switch. Save the lug (with
grounding cable attached) and screws for later use.
Use the appropriate Phillips (+) screwdriver to remove the mounting screws that
2.
attach the chassis front-mounting brackets to the rack or cabinet. Ensure that one
person is supporting the rear of the chassis.
Move the lift to the rack and position it so that its platform is centered about 0.5 in.
3.
(1.27 cm) below the bottom of the switch chassis and as close to it as possible.
Carefully push the switch from the rear, onto the lift. If you have installed the optional
4.
adjustable mounting brackets in a four-post rack, carefully slide the switch from the
adjustable mounting brackets attached to the rack onto the lift.
Use the lift to transport the switch to its new location.
5.

Figure 76: Removing an EX6210 Switch Chassis Using a Mechanical Lift

Removing an EX6210 Switch from a Rack or Cabinet Without Using a Mechanical Lift
on page 206
Chapter 12: Removing the Switch
Figure 76 on page 205):
205