Connecting A Fiber-Optic Cable To An Ex Series Switch; Figure 59: Installing A Transceiver In An Ex Series Switch - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

Connecting a Fiber-Optic Cable to an EX Series Switch

166

Figure 59: Installing a Transceiver in an EX Series Switch

1— Ejector lever
Removing a Transceiver from an EX Series Switch on page 223
Connecting a Fiber-Optic Cable to an EX Series Switch on page 166
Pluggable Transceivers Supported on EX Series Switches
EX Series switches support optical transceivers, which are field-replaceable units (FRUs).
You can connect fiber-optic cables to these transceivers.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in an
EX Series switch, ensure that you have taken the necessary precautions for safe handling
of lasers (see "Laser and LED Safety Guidelines and Warnings for EX Series Switches"
on page 265).
To connect a fiber-optic cable to an optical transceiver installed in an EX Series switch:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
Figure 60 on page
Copyright © 2014, Juniper Networks, Inc.
167).