Figure 39: Installing The Power Cord Tray In A Four-Post Rack - Juniper EX6210 Complete Hardware Manual

Copyright © 2014, Juniper Networks, Inc.
To install the power cord tray (see
Remove the power cord tray from the shipping box.
1.
Decide where to position the switch in the rack. If the rack is empty, choose the lowest
2.
possible location. See "Rack Requirements for an EX6210 Switch" on page
"Cabinet Requirements and Specifications for an EX6210 Switch" on page
Position the power cord tray in the rack space immediately below the position in which
3.
you want to install the switch or where the switch is installed (see
Figure 39 on page 137). Line up the screw holes of the power cord tray with the holes
in the rack. Use 4 mounting screws appropriate for your rack to attach the power cord
tray to the rack.

Figure 39: Installing the Power Cord Tray in a Four-Post Rack

100-1 20V/2
00-24 0V-15
47-63 Hz A
STAN D BY
ON
INPU T OUTP UT
FAIL
OK
OK
Power cord tray
Figure 39 on page 137
0
1
2
3
4
5
6
7
8
9
9
100-1 20V/2
00-24 0V-15
A
47-63 Hz
100-1 20V/2
00-24 0V-15
47-63 Hz A
STAN D BY 100-1 20V/2
ON 00-24 0V-15
47-63 Hz A
INPU T
OUTP UT
FAIL
OK OK
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK OK
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK
OK
Chapter 8: Installing the Switch
and Figure 40 on page 138):
97, and
99.
Adjustable
brackets
(Optional)
137