Removing A Dc Power Supply From An Ex6200 Switch; Figure 78: Removing A 2500 W Ac Power Supply From An Ex6200 Switch; Figure 79: Removing A 5000 W Ac Power Supply From An Ex6200 Switch - Juniper EX6210 Complete Hardware Manual

Related
Documentation

Removing a DC Power Supply from an EX6200 Switch

Copyright © 2014, Juniper Networks, Inc.
NOTE: The power supply cover panels for the 2500 W AC power supply
and 5000 W AC power supply are different. You must use the correct
power supply cover panel to ensure power airflow of the power supplies
installed in the switch. See
page 38 for details about the different power supply cover panels.
CAUTION: Do not overtighten the screws. Applying excessive force might
damage the screws or power supply.

Figure 78: Removing a 2500 W AC Power Supply from an EX6200 Switch

Captive screws
100-1 20V/2
00-24 0V-15
A
47-63 Hz
100-1 20V/2
00-24 0V-15
A
47-63 Hz
STAN D BY
ON
INPU T OUTP UT
OK FAIL
OK
STAN D BY
ON
INPU T
OUTP UT
FAIL
OK OK
100-1 20V/2
47-63 Hz
STAN DBY
INPUT
OUTP UT
OK
OK
Handle

Figure 79: Removing a 5000 W AC Power Supply from an EX6200 Switch

Captive screws
Handle
Installing an AC Power Supply in an EX6200 Switch on page 150
AC Power Supplies in an EX6200 Switch on page 38
The DC power supply in an EX6200 switch is a hot-removable and hot-insertable
field-replaceable unit (FRU). You remove DC power supplies from the front of the chassis.
"AC Power Supplies in an EX6200 Switch" on
9
100-1 20V/2
00-24 0V-15
47-63 Hz A
STAN D BY
ON
INPU T
OUTP UT
FAIL
00-24 0V~1 OK
5A OK
ON
FAIL
8
9
Chapter 13: Removing Switch Components
211