Avaya DEFINITY Server CSI Maintenance Manual page 1524

Maintenance Objects
Error Log Entries and Test to Clear Values
Table 417. Memory Error Log Entries
Error
Type Aux Data
1
0 0
1 Any
3(a) Any
1025 Any
1281 Any
1793 Any (b)(c)
2049(d) Any (b)(c)
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the
appropriate test description and follow the recommended procedures.
Notes:
a. This error (3) indicates that a software patch has been applied and either
the software patch is bad or was installed incorrectly.
1. Back out the software patch and run the test memory a long
b. The Aux Data indicate SIMM Failures.
c. Aux Data of 100 is an LMM Flash Checksum initialization failure.
d. There are Functional Memory Test errors against the Processor circuit
pack. This test is run only via a reset system 4 command or a reset
system 5 command.
1524
Issue 5 October 2002
Associated Test
Any
Flash Memory
Checksum Test (#86)
Flash Memory
Checksum Test (#86)
Memory Parity Error
Detection Test (#87)
Memory Burst Read
Test (#908)
Read All Memory (#85)
Memory Functional
Test (#332)
command to verify that the problem has been cleared.
Alarm On/Off
Level Board
Any Any test memory a l r 1
MAJOR ON test memory a l r 5
MAJOR ON test memory a l r 5
MINOR ON test memory a r 3
MAJOR ON test memory a l r 2
MAJOR ON test memory a l r 1
MAJOR ON test memory a l r 1
Test to Clear Value