Config Bgp Neighbor Password - Extreme Networks ExtremeWare Command Reference Manual

config bgp neighbor password

config bgp neighbor [all | <ip address>] password [none | {encrypted}
<password>]
Description
Configures a password for a neighbor.
Syntax Description
all
ip address
none
encrypted
password
Default
N/A.
Usage Guidelines
When a password is configured, TCP MD5 authentication is enabled on the TCP connection that is
established with the neighbor.
Changes made to the parameters of a peer group are applied to all neighbors in the peer group.
To change any one of the following parameters you must disable and re-enable the peer session:
• timer
• source-interface
• soft-in-reset
• password
Changing a route reflector client will automatically disable and enable the peer session.
The
encrypted
upload configuration
download configuration
Example
The following command configures the password for a neighbor as Extreme:
config bgp neighbor 192.168.1.5 password extreme
History
This command was first available in ExtremeWare 6.2.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies all neighbors.
Specifies an IP address.
Specifies not to use a password
This option is for use only by the switch when generating an ASCII
configuration file. Specifies that the password should be encrypted when the
configuration is uploaded to a file. Should not be used through the CLI.
Specifies a password string.
option is used by the switch when generating an ASCII configuration file (using the
command), and parsing a switch-generated configuration file (using the
command). Do not select the encrypted option in the CLI.
config bgp neighbor password
1059