Installing The Spm Software - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

Installing the SPM Software

2012D transformer
BRIA-4P adapter and 102 connecting block or 103 connecting block
248B adapter
8-position wall jacks
4-pair plug-ended cable
D8W cords
D6AP power cord
EIA-232-D cables
Modem (local or remote) connection
A modem that supports 1200- or 2400-bps connections
In addition, a parallel printer is useful for reports (the PC needs a parallel port
for the connection).
NOTE:
SPM uses Interrupt 4 and I/O address 3F8 for COM1. It uses Interrupt 3 and l/O
address 2F8 for COM2.
Installing the SPM Software
Before you install or run SPM, use diskcopy on a DOS PC (see your operating
system guide) to make a backup copy of the SPM diskette and store the original
in a safe place. Use the backup copy to run the installation program.
For installing SPM on a DOS PC, follow the appropriate instructions in the next
section of this book.
NOTE:
If your PC does not have a hard disk, you do not need to run the installation
program. Go to "Initializing the SPM Software. "
DOS Installation
Use the following procedure to install SPM on the hard drive of a DOS PC.
NOTE:
If you are updating SPM, you do not need to remove the current SPM files The
new files will overwrite your current SPM files.
Considerations
Review the following items before you begin the installation procedure.
2-3
Programming with SPM