Screen Keys - AT&T MERLIN LEGEND Release 3.0 System Programming Manual

Programming Procedures
Single Line Procedure
Console Display/Instructions
1 Specify entry mode.
Select Entry Mode.
2
And s on ...
O
3 Return to Step 6 of
Block of Lines Procedure
Specify the block of 20 lines associated with 20 buttons on the system
1
programming console.
Select Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
2 And so on . . .
3 Return to Step 6 of the main procedure.
Saving Entries and Moving Among Screens
At the bottom of each screen, there are one or more screen keys with functions
that allow you to change your entry, save your entry, or return to a previous
screen. Various combinations of these screen keys appear on each
programming screen. Figure 1-10 shows the QCC Priority screen with a typical
display of screen keys.
QCC Priority x:
Enter line/trunk number
xxx
Backspace
[ F4 ]
[ F5 ] Exit
Figure 1–10. Screen Keys
The PC keys that correspond to the screen key selections are shown here for
quick reference. These PC keys do not appear on the console display screen.
Table 1–2 contains details on the use of the screen keys
1–18
Programming Basics
Additional Information
main procedure.
the
Delete
[ F8 ]
Next
[ F9 ]
Enter
[ F10 ]
x = QCC Priority entered in earlier Step
xxx = line/trunk number (801-880)
PC
[ F6 ]
[ F1 ]
[ F2 ]
[ F3 ]
[ F4 ]