AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 377

Lines and Trunks
Console Display/Instructions
6 Enter the port numbers that have ground-start or loop-start trunks connected.
400 and 408 ports: n = 1 to 4; 800 ports: n = 1 to 8.
**** Start Slot xx:
Enter port no. (1-8)
Backspace Next
Exit Enter
7
Continue to assign trunk types or go to Step 8.
Select Next
8 Save your entry.
Select Enter.
Return to the System Programming menu.
9
Select Exit two times.
Outmode Signaling for Loop-or Ground-Start
Trunks
Use this procedure to identify either touch-tone signaling or rotary-dial signaling
for outgoing calls placed by using the specified loop- or ground-start trunk.
NOTE:
Since the factory setting is touch-tone, this procedure is not required if your
system has only touch-tone lines/trunks.
Summary: Outmode Signaling for Loop-or
Ground-Start Trunks
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Additional Information
**** = option name selected in Step 5
xx = slot number entered in Step 3
NOTE:
If you get the Trunk Busy message, wait
for an idle condition or exit system
programming and try again later.
Dial or type [n].
Return to Step 6. The next slot number
will be displayed on Line 1.
System manager
Loop-Start: All; Ground-Start: Hybrid/pBX only
Not required
Form 2c, System Numbering: Line/Trunk Jacks
Touch-tone
Touch-tone, Rotary
No
Yes
[ F10 ]
[ F5 ] [ F5 ]
Programming Procedures
PC
←
[ F9 ]
4–27