AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 395

Lines and Trunks
QCC Operator to Receive Calls
Summary:
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: QCC Operator to Receive Calls
Console Display/Instructions
1
Select the Lines and Trunks menu.
System Programming:
Make a selection
System Extensions
SysRenumber Options
Operator Tables
LinesTrunks AuxEquip
Exit NightSrvce
2
Go to the second screen of the Lines and Trunks menu.
Lines and Trunks:
Make a selection
LS/GS/DSl PRI
TIE Lines Copy
TT/LS Disc RemoteAccss
DID Pools
Exit Toll Type
System manager
Hybrid/PBX
Not required
Form 2c, System Numbering: Line/Trunk Jacks
No QCC operator is assigned to receive calls.
Extension number of first or fifth extension jack
Yes
No
To program a single line/trunk:
LinesTrunks → More → QCC Oper → Dial ext. no. → Enter →
Select entry mode → Dial line/trunk no. → Enter → Enter →
Enter
To program a block of lines/trunks:
LinesTrunks → More → QCC Oper → Dial ext. no. → Enter →
Select block of lines/trunks → Toggle LED On/Off → Enter
→ Exit → Exit
To program a single line/trunk:
[ F4 ] → [ PgUp ] → [ F4 ] → Type ext. no. → [ F10 ] → [ F6 ] →
line/trunk no. → [ F10 ] → [ F5 ] → [ F5 ]
To program a block of lines/trunks:
[ F4 ] → [ PgUp ] → [ F4 ] → Type ext. no. → [ F10 ] → Select block of
lines/trunks → Toggle letter G On/Off → [ F10 ] → [ F5 ] → [ F5 ]
Additional Information
>
>
Press More.
[ F4 ]
[ PgUp ]
Programming Procedures
PC
4-45