AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 181

Telephones
Console Display/Instructions
4 Save your entry.
Select Enter.
extension.
5 Assign the
Extension :
XXXX
Assign lines/trunks
Entry Mode
– Lines 01-20
– Lines 21-40
– Lines 41-60
– Lines 61-80
Exit
Single Line/Trunk Procedure
1 Specify entry mode.
Select Entry Mode.
2
Enter the line or trunk number.
Extension :
XXXX
Enter line/trunk numbers
Delete
Backspace
Next
Exit
Enter
3 remove
Assign or the
Select Enter or
Delete.
Assign a single line/trunk to the next extension or go to Step 5.
4
Select Next
Return to the System Programming menu.
5
Select Exit two times.
Additional Information
lf you get the Station Busy message, wait
for an idle condition or exit system
programming and try again later.
= extension number entered in Step 3
XXXX
For a single line/trunk, go to
Single Line/Trunk Procedure.
For a block of lines, go to
Block Procedure.
xxxx = extension number entered
in Step 3
specified line/trunk number.
You may continue to assign or remove
lines/trunks by repeating Steps 2 and 3
Return to Step 2 to continue programming. The
next extension will be displayed on Line 1.
Common Administrative Procedures
PC
[ F10 ]
[ F6 ]
←
[ F10 ]
[ F8 ]
[ F9 ]
[ F5 ] [ F5 ]
3–59