AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 557

Optional Group Features
NOTES:
1. If a linear hunting pattern is indicated on the back of the system planning
form (6d), be sure to assign extensions to the group in the exact order
that they are shown on the form. The system searches for an available
member in the order in which you assign the extensions to the group.
2. A maximum of 32 calling groups with a maximum of 20 extensions per
group is allowed.
3. An extension can belong to only one calling group. A QCC cannot be a
member of a calling group. The delay announcement device should not
be programmed as a calling group member.
4. The extension status feature must be set to the Calling Group or CMS
mode before you assign members to the group. See "Extension Status. "
Summary: Group Calling Member Assignments
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Group Calling Line/Trunk or Pool Assignments
Use this procedure to assign or remove lines, trunks, or pools (Hybrid/PBX only)
that ring directly into a calling group.
Incoming calls on each line/trunk or pool can be directed to only one calling
group.
To reassign a line/trunk or pool to a new calling group, you must remove it from
its old group before making the new assignment.
System manager
All
Not required
Form 7c, Group Coverage
Not applicable
Extension numbers
Yes
No
Extensions → More → Grp Calling
calling group ext. no. → Enter → Dial ext. no. → Enter →
Exit → Exit → Exit
[ F6 ] → [ PgUp ] → [ F4 ] → [ F9 ] → Type calling group ext. no. → [ F10 ]
→ Type ext. no. → [ F10 ] → [ F5 ] → [ F5 ] → [ F5 ]
Programming Procedures
→ Members → Dial
4–207