AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 609

Automatic Route Selection
Console Display/Instructions
12
Continue to enter area code or exchange for another table entry number or go to
step 13.
Select Next.
13 Save your entry.
Select Enter.
14 Return to the System Programming menu.
Select Exit two times.
Start and Stop Times for Subpatterns
Use this procedure to specify the time of day that calls are routed using
Subpattern B routing information.
Subpatterns are used to provide two different routing patterns according to the
time of day. This allows you to take advantage of lower rates that may apply to
some or all lines, or to change restrictions on some facilities during off hours.
The stop time for Subpattern B is the start time for Subpattern A.
Enter the time in 4-digit, 24-hour notation, and use leading zeros as necessary.
Summary: Start and Stop Times for Subpatterns
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Additional Information
Return to Step 10. The next table will be
displayed on Line 1.
System manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
Form 3g, Automatic Route Selection Default and
Special Numbers Tables
No time is specified, thus all calls are routed according to
Subpattern A.
0000 to 2359
No
No
Programming Procedures
PC
[ F9 ]
[ F10 ]
[ F5 ] [ F5 ]
4–259