AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 300

System Features
Console Display/Instructions
5 Specify the extension to assign to the allowed list.
Allow To List x
:
Enter extensions to list
Delete
Backspace Next
Enter
Exit
6 Assign or remove the extension from the allowed list.
Select Enter or
Delete.
7
Continue to assign extensions to the next allowed list or go to Step 8.
Select Next
8 Return to the System Programming menu.
Select Exit two times.
Disallowed Lists
Use this procedure to establish Disallowed Lists. These lists are telephone
numbers that cannot be dialed from specified telephones (including
unrestricted telephones).
A maximum of 8 lists (numbered 0 through 7) with 10 entries each (numbered 0
through 9) are allowed. Each number can have a maximum of 11 digits,
including a wildcard.
Summary: Disallowed Lists
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
3–178
Common Administrative Procedures
Additional Information
x = list number entered in Step 3
If no DSS is attached:
SP:
"Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 7.
On = allowed list is assigned.
Off = allowed list is not assigned.
You may continue to assign or remove the
allowed list from additional extensions by
repeating Steps 5 and 6.
Return to Step 5. The next allowed list will
be displayed on Line 1.
System Manager
All
Not required
Form 6g, Call Restriction Assignments and Lists
Not applicable
1- to 11-digits (including 1 wildcard)
PC
←
[ F10 ]
[ F8 ]
[ F9 ]
[ F5 ] [ F5 ]