AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 34

Programming Procedures
Using the Programming Procedures
This section contains specific information about how to make the best use of the
programming procedures. Make certain that you read and understand the
information presented here before you begin any system programming
procedures.
Format
The programming procedures are presented as numbered steps in the format
shown below.
Console/Display Instructions
1 The step instruction is shown here.
Console Display
Press here
2 Enter the B-channel group number ( nn = 1 to 69).
Enter B-Channel Groups: x
Enter the group number:
I
The Gray Bar
The gray bar contains the step number and instructions. The gray bar may also
contain symbols that direct you to a branch procedure. (see "Branching").
Sometimes, the gray bar contains data entry information, which follows the step
instruction and is shown in parentheses. You use the ( nn = ) value in the gray
bar to replace the variable [nn] in the instruction. For example, in sample Step 2
the parenthetical statement ( nn = 1 to 69) indicates that 1 through 69 are
acceptable entries for the group number that you dial or type.
An empty gray bar signals the end of a main procedure.
1–14
Programming Basics
Additional Information
On the PC, press the function key that
appears in the PC column.
x = B-channel entered in Step 1
Dial or type [ nn ].
PC
[ ]
←