AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 45

Programming Procedures
Description
LinesTrunks
Lines/Trunks options
Loop-start, ground-start or DS1 options
LS/GS/DSl
* (DS1) DS1 options
- Type Type of DS1 facility
- T1
- GroundStart Ground-start emulation on selected channels
- Loop Start Loop-start emulation on selected channels
-TIE Tie Trunk emulation on selected channels
- TIE-PBX Tie-PBX transmit/receive loss parameter
- Toll Toll transmit/receive loss parameter
- Unequipped Unused channels
- All Ground
Ground-start emulation on all channels
- All Loop Loopstart emulation on all channels
- All TIE Tie Trunk emulation on all channels
- TIE-PBX Tie-PBX transmit/receive loss parameter
- Toll Toll transmit/receive loss parameter
- All Unequip All channels unequipped
- DID DID emulation on selected channels
- All DID DID emulation on all channels
- PRI Primary Rate Interface
- Frame Format Framing format for the 100D module
- D4 Compatible
- Extended Super
Frame
-Suppression Type of zero code suppression
- AMI ZCS
- B8ZS
Signaling mode
- Signaling
- Robbed Bit
- Common
Channel
- Line Comp Line compensation
- Clock Sync Modules to provide primary, secondary or
- Priority tertiary clock synchronization
- Primary
- Secondary
- Tertiary
- None
- Source Clock Source
- Loop
- Local
- Activation
Clock activation
- Active
- Not Active
Page
4-59
4-64
4-66
4-67
4-70
4-72
1–25
Programming Basics