AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 796

Glossary
Home screen
host
Hybrid/PBX mode
I
ICLID
ICOM buttons
immediate-start tie
trunk
in-band signaling
inside dial tone
Inspect screen
Integrated
Administration
Integrated Services
Digital Network
Integrated Solution
II/III
GL–14
System Programming
Display normally shown on an MLX display telephone;
shows time, date, and call information, and shows when
some features are in use.
Telephone company or other switch providing features
and services to the system users, usually when the system
is operating in Behind Switch mode.
One of three modes of system operation, in which the
system uses trunk pools and ARS in addition to personal
lines. Provides a single interface ( SA buttons ) to users for
both internal and external calling. See also Behind Switch
mode and Key mode.
(Incoming Call Line Identification) A service provided by
some local telephone companies (if local regulations
allow) that supplies the calling party telephone number. In
Release 3.0 and later, an 800 GS/LS-lD module on the
system can capture this information and display it on the
screens of MLX telephones. See also ANI.
(intercom buttons) Telephone buttons that provide access
to inside system lines for calling other extensions or
receiving calls from them.
Tie trunk on which no start signal is necessary; dialing can
begin immediately after the trunk is seized.
See robbed-bit signaling.
A tone users hear when they are off-hook on an SA or
ICOM button.
Display screen on an MLX display telephone that allows
the user to preview incoming calls and see a list of the
features programmed on line buttons.
Capability of IS lII that simplifies the programming of
common information for the system, AUDIX Voice Power,
and, if it is also installed, FAX Attendant System.
See LSDN.
See IS II/III.
-