AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 387

Lines and Trunks
Console Procedure To program a single line/trunk:
PC Procedure
Procedure: Hold Disconnect Interval
Console Display/Instructions
1
Select the Lines and Trunks menu.
System Programming: >
Make a selection
Extensions
System
Options
SysRenumber
Operator Tables
LinesTrunks AuxEquip
NightSrvce
Exit
2 Go to the second screen of the Lines and Trunks menu.
Lines and Trunks:
Make a selection
PRI
LS/GS/DSl
TIE Lines copy
TT/LS Disc RemoteAccss
Pools
DID
Exit Toll Type
Select Hold Disconnect Interval.
3
Lines and Trunks:
Make a selection
HoldDiscnct LS-ID Delay
PrncipalUsr
QCC Prior
QCC Oper
Exit
LinesTrunks → More → HoldDiscnct → Select entry mode
Dial no. of the line/trunk → Enter → Exit → Exit
To program a block of lines/trunks:
LinesTrunks → More → HoldDiscnd → Select block of
lines/trunks → Toggle LED On/Off → Enter → Exit → Exit
To program a single line/trunk:
[ F4 ] → [ PgUp ] → [ F1 ] → [ F6 ] → Type no. of the line/trunk → [ F10 ]
→ [ F5 ] → [ F5 ]
To program a block of lines/trunks:
[ F4 ] → [ PgUp ] → [ F1 ] → Select block of lines/trunks → Toggle
letter G On/Off → [ F10 ] → [ F5 ] → [ F5 ]
Additional Information
>
Press More
>
[ F4 ]
[ PgUp ]
[ F1 ]
Programming Procedures
PC
4–37