AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 659

Memory Card
Card Removed after Confirmation
Memory Card Restore:
RESTORE IS CANCELED.
System is DOWN.
The memory card was removed from the PCMCIA interface slot while the restore
was in progress. The restore
Erase (frigid start). You must
procedure.
Wrong System Programming Port
Restore n :
Change Sys Programming
Port to Extension xxxx
before Restoring.
Exit
The system programming port is not set to the same system programming port
as that set in the backup file. The restore is aborted. Use the
view the port of the file on the card. Change the system programming port to
match the port shown on the card (see "System Programming Position
Assignment") and repeat the restore procedure.
Release Mismatch
Restore n:
File is Not Compatible
for Release X.Y
Restore Canceled.
Conversion Required.
Exit
This screen only appears if you are upgrading from Release 3.0 or higher and
the releases are not compatible.
is aborted and the system performs a System
reinsert the memory card and repeat the restore
n = filename selected
xxxx = system programming port
extension
n = filename selected
X..Y = release number
Programming Procedures
Inspect
feature to
4-309