AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 180

Telephones
Console Procedure To program a single line/trunk:
PC Procedure
Procedure: Assign Trunks or Pools to Telephones
Console Display/Instructions
1 Select the Extensions Menu.
System Programming:
Make a selection
System Extensions
SysRenumber Option
Tables
Operator
AuxEquip
LinesTrunks
Exit NightSrvce
2 Select Lines and Trunks.
Extensions
Make a selection
LinesTrunks Restrct Copy
Line Copy Account
BIS/HFAI
Dial Outed
Restriction Call Pickup
VoiceSignl
Exit
3 Specify the extension.
Assign Lines/Trunks:
Enter extension
Backspace
Exit Enter
3–58
Common Administrative Procedures
Extensions → Lines/Trunks → Dial ext. no. → Enter →
Entry Mode → Dial line/trunk no. → Enter → Exit → Exit
To program a block of lines/trunks:
Extensions → Lines/Trunks → Dial ext. no. → Enter →
Select trunk range → Toggle LED On/Off → Enter → Exit →
Exit
To program a single line/trunk:
[ F6 ] → [ F1 ] → Type ext. no. → [ F10 ] → [ F6 ] Type line/trunk no.
→ [ F10 ] → [ F5 ] → [ F5 ]
To program a block of lines/trunks:
[ F6 ] → [ F1 ] → Type ext. no. → [ F10 ] → Select trunk range →
Toggle letter G On/Off → [ F10 ] → [ F5 ] → [ F5 ]
Additional Information
>
If no DSS is attached:
SP: "Entering an Extension"
If DSS is attached:
Toggle the red LED on or
off as required. Go to Step 5.
On = extension is assigned to
trunk or pool.
Off = extension is not assigned
to trunk or pool.
PC
[ F6 ]
[ F1 ]
←