AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 655

Memory Card
Console Procedure
PC Procedure
Restore
Use this procedure to restore system conditions that were backed up onto a
translation memory card. The information in a backup file on the translation card
is copied to the system.
The restore procedure is necessary under the following conditions:
System RAM is corrupt.
A previously stored set of system conditions is preferred over the current
set.
The processor module is replaced.
After a System Erase (frigid start) has been performed.
The system software has been reinstalled.
The Inspect feature (Inspct or [ PgDn ]) is available to view the attributes of the
backup files on the memory card prior to initiating the restore procedure. The
attributes included on the Inspect screen are the filename, the time and day of
the file creation/update, the location of the system programming port, and
information about the system software release from which the backup was
made.
If any type of programming is taking place at another extension when you begin
the restore procedure, the restore is canceled and the number of the first busy
extension appears on the screen. Repeat the restore procedure when the busy
extension becomes idle.
To program daily backup:
Insert memory card → System → Back/Restore →
Auto Backup → Daily → Drop → Dial time → Enter
→ Exit → Exit
To program weekly backup:
Insert memory card → System → Back/Restore →
Auto Backup → Weekly → Drop → Dial day and time
→ Enter → Exit → Exit
To program daily backup:
Insert memory card → [ F1 ] → [ F9 ] → [ F2 ] → [ F2 ] → [ Alt ] + [ P ] →
Type day and time → [ F10 ] → [ F5 ] → [ F5 ]
To program weekly backup:
Insert memory card → [ F1 ] → [ F9 ] → [ F2 ] → [ F3 ] → [ Alt ] + [ P ] →
Type day and time → [ F10 ] → [ F5 ] → [ F5 ]
Programming Procedures
4-305