AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 585

Remote Access Features
Trunks used for dedicated remote access must not be assigned to ring into a
calling group or the QCC queue (Hybrid/PBX mode only)
In Hybrid/PBX mode, if a trunk assigned to ring into the QCC queue is also used
for shared remote access, perform the procedure below before you perform the
"QCC Operator to Receive Calls" procedure.
NOTE:
A loop start line/trunk must be programmed for Reliable Disconnect if it is to be
used for remote access (see "Disconnect Signaling Reliability").
Summary: Remote Access Trunk Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Remote Access Trunk Assignment
Console Display/Instructions
1 Select the Lines and Trunks menu.
System Programming: >
Make a selection
System Extensions
Options
SysRenumber
Operator Tables
AuxEquip
LinesTrunks
NightSrvce
Exit
System manager
All
Not required
Form 3a, Incoming Trunks: Remote Access
Remote Access is not assigned
Dedicated, Shared, No Remote
Yes
No
LinesTrunks → RemoteAccss → LinesTrunks → Dial
line/trunk no. → Enter → Specify how trunk is used → Enter
→ Exit → Exit
[ F4 ] → [ F8 ] → [ F1 ] → Type line/trunk no. → [ F10 ] → Specify how
trunk is used → [ F10 ] → [ F5 ] → [ F5 ]
Additional Information
Programming Procedures
PC
[ F4 ]
4–235