AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 431

Tie Trunks
Console Display/Instructions
4 Enter the tie trunk number.
**** Trunk Type:
Enter trunk for assignmt
Backspace
Enter
Exit
5 Save your entry.
Select Enter.
6 Specify the tie trunk type.
Trunk xxxx:
Trk type
Select ****
- Wink
– Delay
– Immmed
Next
– Auto
Exit Enter
7
Continue to assign a type to another trunk or go to Stop 8.
Select Next.
Save your entry.
8
Select Enter.
9 Return to the System Programming Menu.
Select Exit two times.
E&M Signal
Use this procedure to specify the type of tie trunk signal, as follows:
E&M Mode
1S. Type 1 Standard. Tie trunks that are connected through the local
telephone company.
1C. Type 1 Compatible. Tie trunks that are connected directly to a
system that uses IS signaling.
Simplex Mode:
5. Type 5 Simplex. Tie trunks that are connected to a system using
Type 5 signaling.
Additional Information
**** = option name selected in Step 3
Dial or type:
Trunk number [ nnn ]
Slot and port number * [ sspp ]
Logical ID number # [ nnn ].
xxxx = trunk entered in Step 4
**** = option name selected in Step 3
Select Wink,
Delay,
Immed, or
Auto.
Return to Step 6. The next trunk will be
displayed on Line 1.
Programming Procedures
PC
←
[ F10 ]
[ F1 ]
[ F2 ]
[ F3 ]
[ F4 ]
[ F9 ]
[ F10 ]
[ F5 ] [ F5 ]
4-81