AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 447

DID Trunks
Console Display/Instructions
5 Save your entry.
Select Enter.
6 Return to the System Programming menu.
Select Exit three times.
Block Procedure
1 Specify the DID trunks associated with 20 buttons on the system programming
console.
Select Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80.
2 Assign or remove the trunk.
3 Return to the System Programming menu.
Select Exit three times.
DID Trunk Type
Use this procedure to specify the DID trunk type as either immediate-start or
wink-start. Wink-starl
Summary: DID Trunk Type
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Additional Information
Toggle the green LED on or
off as required.
On = assign DID trunk to block.
Off = remove DID trunk from block.
is more reliable if the local telphone company supports it.
System manager
Hybrid/PBX
DID trunk idle
Form 3d, Incoming Trunks: DID
Wink-start
Immediate-start, Wink-start
No
No
LinesTrunks → DID → Type → Dial trunk block no. → Enter
→ Immed or Wink → Enter → Exit → Exit
[ F4 ] → [ F45 ] → [ F2 ] → Type trunk block no. → [ F10 ] → [ F1 ] or [ F2 ]
→ [ F10 ] → [ F5 ] → [ F5 ]
[ F10 ]
[ F5 ] [ F5 ] [ F5 ]
[ F3 ]
[ F4 ]
[ F5 ] [ F5 ] [ F5 ]
Programming Procedures
PC
[ F1 ]
[ F2 ]
4-97