AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 396

Lines and Trunks
Console Display/Instructions
3 Select QCC Operator.
Lines and Trunks:
Make a selection
HoldDiscnct
PrncipalUsr
QCC Prior
QCC Oper
Exit
4
Specify the QCC operator extension.
QCC Operator:
Enter QCC operator
extension number
Backspace
Enter
Exit
5 Save your entry.
Select Enter.
6 Specify the line(s) associated
with the QCC operator.
QCC Operator xxxx:
Enter line/trunk number
– Lines 01-20 Entry Mode
– Lines 21-40
– Lines 41-6O
– Lines 61-80
Exit
Single Line Procedure
1 Specify entry mode.
Select Entry Mode.
2 Enter the line/trunk assigned to ring into the QCC queue.
QCC Operator xxxx:
Enter line/trunk number
Delete
Next
Backspace
Exit Enter
4-46
Programming Procedures
Additional Information
>
lf no DSS is attached:
SP:
''Entering an Extension"
lf DSS is attached:
Toggle the red LED on or
off as required. Go to Step 6.
On = operator receiving calls.
Off = operator not receiving calls
xxxx = extension number entered in Step 4
For a single line/trunk, go to
–
Single Line Procedure.
For a block of lines/trunks, go to
Block Procedure.
xxxx = extension number entered in
Step 4
Dial or type:
Trunk number [ nnn ]
Slot and port number * [ sspp ]
Logical ID number # [ nnn ].
PC
[ F4 ]
←
[ F10 ]
[ F6 ]
←