AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 380

Lines and Trunks
Console Display/Instructions
2 Specify touch-tone or rotary signaling for each block.
Return to the System Programming menu.
3
Select Exit three times.
Rotary Trunk Digit Transfer
Use this procedure to designate whether dialed digits on rotary dial lines/trunks
are sent one by one as they are dialed (no delay), or are stored and sent when
dialing is completed (delay). Contact your service provider for more information
about the appropriate setting.
Summary: Rotary Trunk Digit Transfer
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Rotary Trunk Digit Transfer
Console Display/Instructions
1 Select the Options menu.
System Programming:
Make a selection
System Extensions
SysRenumber Options
Operator Tables
LinesTrunks AuxEquip
Exit NightSrvce
4–30
Programming Procedures
Additional Information
Toggle the green LED on or
off as required.
On = touch-tone.
Off = rotary.
System manager
All
Not required
Form 8a, System Features
No Delay
Delay, No Delay
No
No
Options → More → Rotary → Select option → Enter → Exit
[ F7 ] → [ PgUp ] → [ F4 ] → Select Option → [ F10 ] → [ F5 ]
Additional Information
>
PC
[ F5 ] [ F5 ] [ F5 ]
PC
[ F7 ]