AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 436

Tie Trunks
Block Procedure
1 Specify the biotic of 2U lines associated with the 20 line buttons on the system
programming console.
Select Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80.
2 Specify touch-tone or rotary signaling for each line/trunk.
Return to the System Programming menu.
3
Select Exit three times.
Tie Trunk Dial Tone
Use this procedure to specify whether the system provides dial tone for people
calling in on a tie trunk. Settings are remote (system provides dial tone) and
local (system does not provide dial tone).
Summary: Tie Trunk Dial Tone
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
4-86
Programming Procedures
Toggle the green LED on or
off as required.
On = touch-tone.
Off = rotary.
System manager
All
Not required
Form 3c, Incoming Trunks: Tie
Remote
Remote, Local
Yes
Yes
LinesTrunks → TIE Lines → Dialtone → Entry Mode → Dial
trunk no. → Enter or Delete → Exit → Exit → Exit
To program a block of lines/trunks:
LinesTrunks → TIE Lines → Dialtone → Select block of
lines/trunks → Toggle LED On/Off → Exit → Exit → Exit
[ F1 ]
[ F2 ]
[ F3 ]
[ F4 ]
[ F5 ] [ F5 ] [ F5 ]