AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 265

System Features
One-Touch Transfer/One-Touch Hold
Use this procedure to assign the One-Touch Transferor One-Touch Hold
feature.
One-Touch Transfer allows users to initiate transfers to another extension by
pressing an Auto Dial or DSS button for that extension. If the One-Touch
Transfer feature is assigned, you must also specify whether the transfer
completion is manual (the user has to press another button to complete the
transfer) or automatic (the transfer is completed automatically).
The One-Touch Transfer feature is not available on single-line telephones.
One-Touch Hold applies to incoming central office calls only. When the user
presses an Auto Dial or DSS button to initiate a transfer, the outside caller is put
on hold. The system automatically selects an intercom facility and dials the
transfer destination. There is no transfer return function with this method.
Consequently, if the transfer destination does not answer or is busy, the user
who initiates the transfer must notify the outside caller, or the outside caller will
remain on hold.
One-Touch Hold is the factory setting in Behind Switch mode only
Summary: One-Touch Transfer/Hold
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
System Manager
All
Not required
Form 8a, System Features
One-Touch Transfer, automatic completion (One-Touch
Hold is the factory setting in Behind Switch mode.)
Transfer, Hold
No
No
Common Administrative Procedures
3–143