AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 621

Automatic Route Selection
Other Digits
Use this procedure to specify other (extra) digits that must be added by the
system to the beginning of the number dialed by the caller, when calls are
placed on an identified route.
NOTES:
1. Pool routes must be programmed before you assign other digits.
2. A maximum of 20 digits can be added, in any combination of the digits 0
through 9.
3. Special characters such as switchhook flash, Stop, and # cannot be
included as extra digits. Pause is allowed in every position but the first.
4. Other digits are assigned to Tables 1 through 18.
Summary: Other Digits
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Other Digits
Console Display/Instructions
1 Select the Tables menu.
System Programming:
Make a selection
System Extensions
Options
SysRenumber
Operator Tables
LinesTrunks AuxEquip
Exit NightSrvce
System manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
0
Up to 20 digits (any combination of 0 to 9)
No
No
Tables → ARS → Sub A Digit or More and Sub BDigit →
Dial table no. and pool route no. → Enter → Drop → Dial
digits to be added → Enter → Exit → Exit
[ F8 ] → [ F6 ] → [ F7 ] or [ PgUp ] and [ F3 ] → Type table no. and pool
route no. → [ F10 ] → [ Alt ] + [ P ] Type digits to be added → [ F10 ]
→ [ F5 ] → [ F5 ]
Additional Information
>
Programming Procedures
PC
[ F8 ]
4–271