AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 469

PRI Facilities
Network Service
Use this procedure to specify the type of outgoing service provided by each
B-channel group [Megacom WATS and 800, MultiQuest
Switched Digital Service (SDS), or Software Defined Network (SDN)].
NOTE:
You can enter a service not shown on the Network Service screen by using the
five-digit binary code that represents the service in the Network Facilities
Information Element of ISDN PRI signaling protocol. For information on these
codes, contact your service provider. See "Miscellaneous Procedure. "
Summary: Network Service
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: Network Service
Console Display/Instructions
1 Select the lines and Trunks menu.
System Programming:
Make a selection
System Extensions
SysRenumber Options
Operator Tables
LinesTrunks AuxEquip
Exit NightSrvce
System
manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(1OOD module)
Not applicable
AT&T Toll, Local, Miscellaneous
No
No
LinesTrunks → PRI → B-ChannlGrp → NetworkServ → Dial
group no. → Enter → Specify network service → Enter →
Exit → Exit → Exit → Exit
[ F4 ] → [ F6 ] → [ F2 ] → [ F3 ] → group no. → [ F10 ] → Specify
network service → [ F10 ] → [ F5 ] → [ F5 ] → [ F5 ] → [ F5 ]
Additional Information
>
Programming Procedures
® ®
Service, ACCUNET
PC
[ F4 ]
4–119