AT&T MERLIN LEGEND Release 3.0 System Programming Manual page 465

PRI Facilities
Summary: B-Channel Groups
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
Procedure: B-Channel Groups
Console Display/Instructions
1 Select the Lines and Trunks menu.
System Programming:
Make a selection
System Extensions
Options
SysRenumber
Operator Tables
AuxEquip
LinesTrunks
Exit NightSrvce
System manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
Not applicable
Group numbers (1 to 80)
Yes
No
To program a single line/trunk:
LinesTrunks → PRI → B-ChannlGrp → B Channels → Dial
group no. → Enter → Dial B-channel slot and port nos. →
Enter → Lines → Dial group no. → Enter → Entry Mode →
Dial line/trunk no. → Enter → Exit → Exit → Exit
To program a block of lines/trunks:
LinesTrunks → PRI → B-ChannlGrp → B Channels → Dial
group no. → Enter → Dial B-channel slot and port no. →
Enter → Lines → Dial group no. → Enter → Select specific
lines/trunks → Toggle LED On/Off → Exit → Exit → Exit
To program a single line/trunk:
[ F4 ] → [ F6 ] → [ F2 ] → [ F1 ] → Type group no. → Type B-channel
slot and port nos. → [ F5 ] → Type group no. → [ F10 ] → [ F6 ] →
Type line/trunk no. → [ F10 ] → [ F5 ] → [ F5 ] → [ F5 ]
To program a block of lines/trunks:
[ F4 ] → [ F6 ] → [ F2 ] → [ F1 ] → Type group no. → Type B-channel
slot and port nos. → [ F5 ] → Type group no. → [ F10 ] → Select
specific lines/trunks-Toggle letter G On/Off → [ F5 ] → [ F5 ]
→ [ F5 ]
Additional Information
>
Programming Procedures
PC
[ F4 ]
4–115