Configuring The Instant Internet Unit; Configuring The Unit For Your Network - Nortel BayStack 100-S Install Manual

32 Chapter 3 Installing the Instant Internet software

Configuring the Instant Internet unit

The first step when installing an Instant Internet unit is to configure the unit for
your network.
Before you begin, if you have an existing DHCP server and want to continue
using it, you must set up your server according to the information in
TCP/IP network with an existing BootP or DHCP server" on page
If you need help entering information in a dialog box, press [F1] for online Help.

Configuring the unit for your network

Before you start the Instant Internet Install program, make sure that LED 2 on the
front panel of the unit is glowing amber.
If you are connecting an Ethernet device (for example, a router, a cable modem, or
xDSL modem) or 1-Meg modem, ensure that the device is plugged in and has an
active connection to your ISP.
209226-B
Note: Read through these installation procedures one time before you
attempt to install and configure the Instant Internet unit. Knowing what
is expected during the installation helps the entire process go more
smoothly.
Caution: DO NOT PROCEED if LED 2 is not glowing amber. For
more information on interpreting LED indicators, refer to the hardware
guide for your Instant Internet unit.
"Preparing a
76.