Move Tds/Dtr And Keep Sdi Ports - Nortel Meridian 1 Option 11C Upgrade Manual

Page 138 of 224

Move TDS/DTR and keep SDI ports

553-3021-250 Standard 7.00
Assign TDS/DTR, XTD, and SDI functions
To move TDS/DTR, you must remove the TDS/DTR function from the
NTAK03 TDS/DTR card and then assign it to slot 0.
Note: Perform the steps below in the order indicated. You must assign
the TDS to the SSC card in slot 0 before you program the DTR units. You
must disable the TDS/DTR card before removing the TDS from that card
slot.
Procedure 13
Move TDS/DTR while keeping SDI ports
1 Disable the NTAK03 TDS/DTR card in LD 34.
Use the DISX N command where N is the card slot number of the
TDS/DTR card.
2 Configure TDS on the SSC card using LD 17 (see Table 14).
Table 14
LD 17 - Configure TDS on SSC card
Prompt Response
REQ CHG
TYPE CFN
CEQU YES
TDS 0
3 Remove the eight DTR units on the TDS/DTR card using LD 13
(see Table 15).
Make sure you remove all eight units.
Table 15
LD 13 - Remove DTR units on TDS/DTR card.
Prompt Response
REQ OUT
TYPE DTR
TN c u
April 2000
Comments
Change.
Configuration data block.
For changes to common
equipment
Tone and Digit switch for the
NTDK20 SSC card.
Comments
Remove information
Digitone receivers data block
c = card slot of the TDS/DTR
card
u = 0 to 7 (Repeat until you
remove all eight units.)