To Cancel Hot Desking; To Configure A New Time Zone On A Remote Ip Telephone; Configuring A New Time Zone On A Remote Ip Telephone - Nortel BCM50 2.0 Configuration Manual

150 Chapter 20 Global VoIP features
4 Enter the DN of the telephone you want to divert to this telephone.
Note: If the originating telephone does not allow Hot desking, a Not
allowed prompt displays. This prompt also occurs if the originating
telephone is on a call when the diversion command is issued.
5
Enter the password of the diverted telephone.
The buttons on your telephone mimic the buttons configured on the diverted set. The diverted
telephone indicates that it is diverted, and it cannot be used until Hot desking is cancelled.
Cancelling Hot desking
You can cancel Hot desking from the originating or target telephone.

To cancel Hot desking

1 Ensure that both telephones are on-hook before cancelling Hot desking.
Note: There can be up to a ten-second delay after the call ends before
the system allows you to cancel Hot desking. This period can vary,
depending on the call type.
2 Cancel the feature:
Diverted telephone: Press the display key under the CANCEL prompt.
Live telephone:
a Access FEATURE *999.
b Enter the password.
c
Press CANCEL.

Configuring a new time zone on a remote IP telephone

If the IP telephone connects to the system from a different time zone than the system, you can reset
the telephone to display the correct local time.

To configure a new time zone on a remote IP telephone

1 At the telephone, enter FEATURE *510.
2
Press CHANGE.
3 Press * to toggle between + (plus) and - (minus). Use + if local time is ahead of system time;
typically, you use + when the system is west of the local site.
4
Enter the number of hours difference.
NN40020-300 NN40020-300