Honda NC700 2012 Service Manual page 766

dummyhead dummyhead
ECM (NC700X/XA/S/SA)/PCM
(NC700XD/SD)
INSPECTION
Remove the shroud/side cover (NC700X/XA) (page 2-
NC700X/XA/S/SA:
14).
Remove the side cowl (NC700S/SA) (page 2-13).
Turn the ignition switch OFF.
Disconnect the ECM 33P (Black) connector [1].
Perform the following inspections at the wire harness
side connector of the ECM.
Remove the luggage box lid/hinge assembly (page 2-
NC700XD/SD:
19).
Turn the ignition switch OFF.
Disconnect the PCM 33P (Gray) connector [1].
Perform the following inspections at the wire harness
side connector of the PCM.
POWER INPUT LINE INSPECTION
Turn the ignition switch ON and engine stop switch " ".
Measure the voltage between the ECM/PCM 33P
connector [1] terminal and ground.
CONNECTION: Black (+) – Ground (–)
STANDARD:
TOOL:
Test probe
There should be battery voltage.
Battery voltage
07ZAJ-RDJA110
IMMOBILIZER SYSTEM (HISS)
NC700X/XA/S/SA:
[1]
NC700XD/SD:
[1]
[1]
Bl
23-11