Honda NC700 2012 Service Manual page 238

dummyhead dummyhead
Remove the shroud/side cover (NC700X/XA/XD) (page
2-14).
Remove the side cowl (NC700S/SA/SD) (page 2-13)
With the ignition coil primary wire connected, connect
Do not disconnect
the peak voltage adaptor or Imrie tester to the ignition
the ignition coil
coil primary terminal [1] and ground.
primary wire.
TOOL:
Imrie diagnostic tester (model 625) or
Peak voltage adaptor
with commercially available digital multimeter
(impedance 10 MΩ/DCV minimum)
CONNECTION:
No.1: Blue/yellow (+) – Ground (–)
No.2: Yellow/blue (+) – Ground (–)
Turn the ignition switch ON and engine stop switch " ".
Check the initial voltage at this time.
The battery voltage should be measured.
If the initial voltage cannot be measured, follow the
checks described in the troubleshooting table (page 5-
5).
Shift the transmission into neutral.
Crank the engine with the starter motor and measure
Avoid touching the
the ignition coil primary peak voltage.
spark plug and
tester probes to
PEAK VOLTAGE: 100 V minimum
prevent electric
shock.
If the peak voltage is abnormal, follow the checks
described in the troubleshooting table (page 5-5).
Install the shroud/side cover (NC700X/XA/XD) (page 2-
14).
Install the side cowl (NC700S/SA/SD) (page 2-13).
CKP SENSOR PEAK VOLTAGE
(NC700X/XA/S/SA)
Check the cylinder compression and check that the
spark plugs are installed correctly in the cylinder head.
Disconnect the ECM 33P (Black) connector [1] (page 4-
67).
Connect the peak voltage tester or adaptor probes to
the ECM 33P (Black) connector terminals of the wire
harness side.
TOOLS:
Imrie diagnostic tester (model 625) or
Peak voltage adaptor [2]
with commercially available digital multimeter
(impedance 10 MΩ/DCV minimum)
Test probe
CONNECTION: Yellow (+) – Green/orange (–)
Shift the transmission into neutral.
Turn the ignition switch ON and engine stop switch " ".
Crank the engine with the starter motor and measure
the CKP sensor peak voltage.
PEAK VOLTAGE: 0.7 V minimum
If the peak voltage measured at the ECM 33P (Black)
connector is abnormal, measure the peak voltage at the
CKP sensor connector.
07HGJ-0020100
07HGJ-0020100
07ZAJ-RDJA110
[1]
IGNITION SYSTEM
[2]
Y G/O
[1]
5-7