Honda NC700 2012 Service Manual page 190

dummyhead dummyhead
3. IAT Sensor Voltage Output Line Short Circuit
Inspection
Turn the ignition switch OFF.
Check for continuity between the IAT sensor 2P
(Black) connector [1] of the wire harness side and
ground.
Connection: Gray/blue – Ground
Is there continuity?
YES
NO
DTC 9-2 (IAT SENSOR HIGH
VOLTAGE)
• NC700X/XA/S/SA:
Before starting the inspection, check for loose or
poor contact on the IAT sensor 2P (Black) connector
and ECM 33P (Black) connector, then recheck the
DTC.
• NC700XD/SD:
Before starting the inspection, check for loose or
poor contact on the IAT sensor 2P (Black) connector
and PCM 33P (Gray) connector, then recheck the
DTC.
• If the ECM/PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (NC700XD/
SD) (page 12-120)
1. IAT Sensor System Inspection
Turn the ignition switch ON and engine stop switch
" ".
Check the IAT sensor with the HDS pocket tester.
Is about 5 V indicated?
YES
NO
2. IAT Sensor Inspection
Turn the ignition switch OFF.
Disconnect the IAT sensor 2P (Black) connector [1].
Connect the IAT sensor 2P (Black) connector
terminals at the wire harness side with a jumper wire
[2].
Connection: Gray/blue – Green/yellow
Turn the ignition switch ON.
Check the IAT sensor with the HDS pocket tester.
Is about 0 V indicated?
YES
NO
– Short circuit in the Gray/blue wire
– Replace the ECM/PCM with a known good
one, and recheck.
– GO TO STEP 2.
– Intermittent failure
– Faulty IAT sensor
– GO TO STEP 3.
PGM-FI SYSTEM
[1]
Gr/Bu
[1]
Gr/Bu G/Y
[2]
4-29